Crazepony 16pcs DALPROP T5045C 5045 5043 51499 Props 5 Inch 3-Blades Tri-Blade Propeller Review (2026)

What it is and who it's for

This is a 16 piece pack of 5 inch tri-blade propellers sold by Crazepony, based on the DALPROP T5045C Cyclone design and marketed to also cover 5043 and 51499 pitch labeling. It suits FPV pilots running 200, 210, 230 or 250 millimeter racing frames who go through props quickly during practice, freestyle sessions, or club racing. Because it ships as 16 pieces, that works out to four full sets, which is enough to survive several hard landings or prop strikes without an immediate reorder. It is a reasonable pick for someone building their first 5 inch quad who wants backup props on the shelf from day one, or for a pilot who already knows the Cyclone shape and wants a cheaper bulk source for the same blade profile they already fly.

Design and materials

The Cyclone T5045C style propeller uses a three blade layout molded from a glass fiber reinforced polycarbonate blend, a material choice that shows up across most DALPROP branded props sold under this Cyclone name. The three blade design trades a little top end efficiency for stronger punch out and steadier tracking through corners compared with a two blade prop of the same size, which is part of why tri-blade props remain popular for freestyle and technical racing lines. Props ship in matched clockwise and counter clockwise pairs so each motor spins the correct direction, and the pack mixes colors so pilots can tell front from back props at a glance during a preflight check. The hub is sized for the standard 5 millimeter motor shaft used on most 2205 to 2307 class brushless motors.

Performance in the air

Tri-blade 5 inch props like this one are generally chosen for their punch out power and predictable handling rather than outright top speed or maximum flight time. The extra blade adds thrust at low throttle, which helps with tight technical flying through gaps and trees, and it tends to feel more locked in during hard cornering than a two blade prop. The trade-off pilots should expect is higher current draw for the same throttle position, since three blades push more air and load the motor harder, which shortens flight time slightly compared with a two blade prop of similar pitch. Riders chasing maximum efficiency for long range flying usually look at two blade options instead, while freestyle and racing pilots tend to prefer the tri-blade feel this pack offers.

Fit and compatibility

The listing states compatibility with 200, 210, 230 and 250 millimeter FPV racing drone frame kits, which covers most standard 5 inch quad builds. The 5 millimeter center hole fits the majority of 2205 through 2307 brushless motor shafts used on these frame sizes, so fitment is rarely an issue once the frame and motor size are already known. Pilots running unusual motor shaft diameters or oversized props on very large 5 inch frames should double check clearance against their specific arm length before ordering in bulk. Because the pack blends 5045, 5043 and 51499 labeling, buyers should treat it as a general 5 inch tri-blade replacement rather than a precision match to one exact pitch spec, which is fine for most recreational and club level flying.

Value and what to watch for

At 16 pieces for four sets, the per prop cost is low compared with buying single four packs from a name brand shelf, which is the main appeal here. The trade-off is that this is a reseller listing rather than a direct DALPROP storefront, so buyers should confirm they are receiving genuine Cyclone molded props and not a lower quality copy, particularly if a batch arrives with visible flashing or uneven blade balance. For casual practice, line of sight flying, or backup stock, the value case is strong. Pilots who race competitively and rely on consistent balance from prop to prop may still want to hand check or balance each one before a race weekend, which is good practice with any bulk prop purchase regardless of brand.

Frequently asked questions